Crown Com-Tech CT-200 Betriebsanweisung PDF herunterladen (Seite 16)

ASTi Crown

Power Amplifier User Guide (Ver. 1, Rev. E)

Chapter 3: General Information

3.1. Front Indication Lights

• Bridge Mode Indicator – illuminates yellow when the channel pair is set to the “Bridge”

position. If the bridge mode is changed while the amplifier is powered on it must be pow-

ered off and back on to reset the mode.

• Ready Indicator – illuminates green when the channel is initialized and ready to produce

audio output.

• Signal Indicator – illuminates green to indicate the presence of input signals above -

40dBu.

• Clip Indicator – illuminates red when the THD of the channel’s output signal rises to a

level typically considered as the onset of audible clipping.

• Thermal Indicator – illuminates red when the channel has shut down due to thermal stress

or overload.

• Fault Indicator – illuminates red when the output channel has stopped operating.

• Power Indicator – illuminates blue when the amplifier is on and the AC power is available.

This will also flash if the amplifier shuts off from under/over voltage conditions.

• Data Indicator – illuminates yellow when a command is received by the module.

Bridge Mode Indicator

Ready Indicator

Clip Indicator

Signal Indicator

Thermal Indicator

Fault Indicator

Data Indicator

Power Indicator

Power Switch

Figure 7: Front Panel Indication Lights

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Crown Com-Tech CT-200 Betriebsanweisung Seite 16