Crown Com-Tech CT-200 Betriebsanweisung PDF herunterladen (Seite 13)

ASTi Crown

Power Amplifier User Guide (Ver. 1, Rev. F)

2.2.1. Multiple Crown Amplifiers on the ACENet

All Crown amplifiers come pre-configured with the same IP address and when using two or more

on the same ACENet network they will not function properly in the System Architect software

until one IP address is changed. ASTi recommends changing all IP addresses if using multiple

Crown amplifiers on the same ACENet network.

If you try to use two or more Crown amplifiers on a common ACENet network with the Harman

Audio “System Architect” software to set-up the internal DSP features (filters, delay, power limit-

ing, etc.) it will only report that one amp is online via System Architect; the others will be

“offline”. The software will find the amps, but all but one will be grayed out. The network trou-

bleshooter will repeatedly try to instruct you to reconfigure the network interface of the PC that is

running System Architect.

There are two applications available from Harman Audio that will help resolve this issue:

1) System Architect via “Tools” and “Readdress Devices”

2) HiQnet NetSetter which is available at http://hiqnet.harmanpro.com/software/netsetter/

One amp should remain configured with the default IP address of 192.168.1.1 and set any addi-

tional amps with incrementing IP addresses (i.e. 192.168.1.2, etc.).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Keine Kommentare

Crown Com-Tech CT-200 Betriebsanweisung Seite 13